加拿大28

Welcome to Dongguan Tai Fu Machinery Co。, Ltd。 official website

Dongguan Tai Fu Machinery Co., Ltd.

Dongguan Tai Fu Machinery Co., Ltd.

Focus on the production and manufacture of injection molding machine for 10 years, national high-tech enterprise

South China:136-8666-5453

East China:139-2550-8791

Contact
TEL:13686665453

Contacts:Manager Zeng
phone:13925508791
Email:2994331754@qq.com
address:Fulong Yangwu Industrial Zone,Shipai Town,Dongguan City,Guangdong Provice,China

history record

Injection Abnormality of Automatic Vertical Injection Moulding Machine

source:   time:2019-07-12   Click:271

Injection abnormality is a common malfunction of automatic vertical injection moulding machine, but it is often confusing. Where is the problem? There is no way to solve it. The abnormal ejection is mainly caused by the following four reasons:

1. The limit proximity switch before the shooting seat is not confirmed (in automatic operation) or damaged: its position is adjusted or replaced.

vertical injection moulding machine

2。 No injection action: adjust its position or change it。

(1) Manual injection button damage (manual state): Replace the button。

(2) Alarm barrel temperature is too low: wait for barrel temperature to rise to the set value.

(3) The coil of the ejector solenoid valve burns out or gets stuck: replace the coil or clean the solenoid valve.

(4) The pressure is too low and the injection time is not set: increase the injection pressure or set the injection time.

(5) The temperature of injection moulding is too low: adjust the setting value to raise the temperature to the required point. If adjusting the setting value can not increase the temperature, check whether the heating ring and contactor are burnt out, and replace them if they are broken.

3。 Wear or fracture of screw head check ring: Replace screw head check ring。

4. There is foreign matter in the barrel, which causes blockage of feeding nozzle: cleaning barrel and feeding nozzle.

If the injection abnormality of the fully automatic vertical injection moulding machine you purchased in Taifu is not the above four reasons or can not be solved by yourself, please contact Taifu Customer Service to arrange after-sales service for you, and handle the problem for you within 24 hours!

vertical injection moulding machine

This article is an original article of Dongguan Taifu Machinery Co。, Ltd。 (Official Website: www。dg-taifu。com/www。taifu6。com)。 It shall not be reproduced without permission。

Popular tags:Vertical Injection Moulding Machine
CONTACT THE TAIFU

Contact: Manager Zeng

Mobile phone:13925508791

Fax:0769-81929375

email:2994331754@qq.com

Address: Fulong Yangwu Industrial Zone,Shipai Town,Dongguan City,Guangdong Provice,China

Copyrights©2018 Dongguan Tai Fu Machinery Co., Ltd. All Rights Reserved case number:

香港开奖结果2019+开奖记录表 河北11选5走势图 福建11选5 湖北快3开奖 百胜彩票投注 银河彩票投注 奔驰现金网 全民彩票 万家彩票开户 广西快3计划